If the end system is directly connected to the layer 3 switch, the "show arp" output on EXOS and EOS shows the port as well as the ARP information. EXOS will build an ARP cache if it has an IP interface in the VLAN, even if forwarding is not enabled. Entries in this cache can time out, just like MAC addresses in the FDB. This can show you which ports an IP address was seen on.ĭHCP snooping builds a database of IP to MAC bindings and can be used to connect an IP address to a port on a layer 2 switch.Ī layer 3 switch will build an ARP cache. Thus it is not always possible to provide the information you seek.ĮOS switches (and EXOS 22.2) provide the so called "Node Alias Table," which saves information about packets seen on switch ports. EAC (formerly NAC) is a better solution for this.Ī pure layer 2 switch may just know the MAC address, but not the IP address of a connected end system. EMC compass is a good choice if available, because it queries all switches and thus allows to easily correlate the info.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |